Hi Beemers,
do some one know how to get out the situated in the head lamp of my R26.
This plate has No 61 32 8 048 173 Noris or Bosch.
Thank You.
Contact Switch Box/plate R26
Re: Contact Switch Box/plate R26
It is retained by four metal tabs that are part of the headlight shell. Insert a fine screwdriver under each tab only enough so you can use a curved needle nose pliers on the tab to bend it some more release the plate or board.
Be very careful and do not bend the tabs any more than necessary. The tabs will break after a few bendings, from metal fatigue. The factory bent once to install, then you will bend twice to remove and reinstall. But you don't know if anybody else bent the tabs in the past 50 years. If you break a tab, there is no repair.
Be very careful and do not bend the tabs any more than necessary. The tabs will break after a few bendings, from metal fatigue. The factory bent once to install, then you will bend twice to remove and reinstall. But you don't know if anybody else bent the tabs in the past 50 years. If you break a tab, there is no repair.
Re: Contact Switch Box/plate R26
In fact the four tabs can be repaired as I have carried out the work successfully on several occasions, but it is a tricky job.
Shape a suitable piece of metal, drill and attach it to the original stub by means of a small pop rivet. A small diameter drill and the pop rivet tool will just fit between the stub and headlight rim, but you need to be accurate and careful.The new tab must not be too long or it may foul the board contact posts when bent over.
Alternatively,I'm sure a skilled welder could replace the broken tab, but the heat might damage the external paint finish. Still, what price a new shell?
Shape a suitable piece of metal, drill and attach it to the original stub by means of a small pop rivet. A small diameter drill and the pop rivet tool will just fit between the stub and headlight rim, but you need to be accurate and careful.The new tab must not be too long or it may foul the board contact posts when bent over.
Alternatively,I'm sure a skilled welder could replace the broken tab, but the heat might damage the external paint finish. Still, what price a new shell?
Re: Contact Switch Box/plate R26
"... what price a new shell?"
63 12 8 050 031 Headlight complete "BOSCH" without dimmer switch R26 - R69S 684.00 CHF or 587 USD
63 12 8 050 031 Headlight complete "BOSCH" without dimmer switch R26 - R69S 684.00 CHF or 587 USD
Re: Contact Switch Box/plate R26
To &
Hi Guys,
thank you for the tip.
Hi Guys,
thank you for the tip.