Earles Forks
Posted: Thu 6. May 1999, 01:03
G'day Mark et al,
I'm building up an R90/2 conversion and intend installing a twin disc brake into the Earles fork.
I've come across a minor problem in setting up the front wheel.
According to my measurements, the lateral distance from the horizontal centre line of the leading link to the right hand side of the link (at the wheel axle) is 5mm greater than the same measurement to the left hand side.
If possible, advice as to the correct RHS offset would be greatly appreciated.
Regards,
Lloyd
I'm building up an R90/2 conversion and intend installing a twin disc brake into the Earles fork.
I've come across a minor problem in setting up the front wheel.
According to my measurements, the lateral distance from the horizontal centre line of the leading link to the right hand side of the link (at the wheel axle) is 5mm greater than the same measurement to the left hand side.
If possible, advice as to the correct RHS offset would be greatly appreciated.
Regards,
Lloyd