Header Question
Posted: Wed 22. Mar 2000, 00:36
Simple: Will an R50S header fit on an R50 or will an R69S header fit on an R60?
I am actually considered with the junction between the head and the pipe rather
than the length and shape of the pieps themselves. The R50S and R69S, I believe fit
on the head with a "compression joint" where as the R60/2 and R50/2 screw onto the
head. Are these two systems incompatible?
Of course I could be wrong about everything. Someone please let me know.
I am actually considered with the junction between the head and the pipe rather
than the length and shape of the pieps themselves. The R50S and R69S, I believe fit
on the head with a "compression joint" where as the R60/2 and R50/2 screw onto the
head. Are these two systems incompatible?
Of course I could be wrong about everything. Someone please let me know.