i noticed that my horn does not working, when i push the horn botton i here a very queit 'beep', i changed it to a new one and the problem still as it was.
does anyone know what should i check?
horn doesnt work
-
Bruce Frey
Re: horn doesnt work
It sounds like a low voltage situation that could be caused by dirty connections or corrosion. The horn button would be suspect.
Is your new horn the correct voltage for your system (i.e., 6v horn on a 6v system)?
Best regards and good luck
Bruce
Is your new horn the correct voltage for your system (i.e., 6v horn on a 6v system)?
Best regards and good luck
Bruce
-
Pierre Michaud
Re: horn doesnt work
What exactly did you change...the horn or the button?. If you changed the button then
your problem could be either a dead battery or a 6volt battery trying to sound a 12 volt
horn.
If you changed the horn then perhaps both horns are 12 volt and your battery is 6 volt or
nearly dead. Another possibility could be that both horns were defective and need to
have their "points" adjusted or the wiring from your horn button to your horn is diverting
current in another area.
your problem could be either a dead battery or a 6volt battery trying to sound a 12 volt
horn.
If you changed the horn then perhaps both horns are 12 volt and your battery is 6 volt or
nearly dead. Another possibility could be that both horns were defective and need to
have their "points" adjusted or the wiring from your horn button to your horn is diverting
current in another area.