Page 1 of 1
plunger rear suspension
Posted: Thu 11. Jan 2001, 02:50
by scott schmidt
Could someone advise me on how to remove the rear shocks from a 1951 plunger frame. I removed the driveshaft, wheel and top shock nut, and loosened the remaining bolts. Many thanks. Scott
Re: plunger rear suspension
Posted: Thu 11. Jan 2001, 19:16
by stacey zabolotney
You have to tap out the big center pin from the BOTTOM out through the top. There is a fellow that makes this drift specifically for the plunger. Go to "beemergarage.com" and click on factory tools.
Re: plunger rear suspension
Posted: Mon 15. Jan 2001, 22:34
by Bruce Frey
I used an old 1/2" drive socket of the appropriate OD and a long extension instead of the special tool.
Good luck,
Bruce