plunger rear suspension

[scott schmidt]

Could someone advise me on how to remove the rear shocks from a 1951 plunger frame. I removed the driveshaft, wheel and top shock nut, and loosened the remaining bolts. Many thanks. Scott

[stacey zabolotney]

You have to tap out the big center pin from the BOTTOM out through the top. There is a fellow that makes this drift specifically for the plunger. Go to "beemergarage.com" and click on factory tools.

[Bruce Frey]

I used an old 1/2" drive socket of the appropriate OD and a long extension instead of the special tool.

Good luck,

Bruce